Buchi Pump Module C-605 Manual de usuario Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 50
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
5 Putting into operation
20 Pump Combinations Operation Manual, Version E
1
3
42
Connect the pump module a to the pump control-
ler b via data bus RS-485 by means of the cable
RJ45 d.
c TTL IN/OUT.
Fig. 5.6: Rear connections of pump controller and pump module
The overpressure sensor switches off the pump if the pressure exceeds 10 bar. This maximum pres-
sure of 10 bar cannot be changed. The installation of the overpressure sensor is easy to do and
explained in the following:
Overpressure sensor
Clip the overpressure sensor onto the Pump Module
C-601.
Connect the overpressure sensor to the correspon-
ding connector TTL IN/OUT at the back of the Pump
Controller C-610.
Fig. 5.7: Installing the overpressure sensor
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Comentarios a estos manuales

Sin comentarios