Buchi KjelSampler K-377 Manual de usuario descargar pdf (Pagina 93)

6 Operation

K-375/376/377 Operation Manual, Version B

6.7.3 Blank Correction

The blank correction can be switched on and off:

HOME  Blank Correction  SETTINGS

ON Blank correction of results is switched on.

OFF Blank correction of results is switched off –

no blank correction at all will be performed.

Within the Blank Correction main screen a list of the latest blanks can be viewed. By adapting the

parameter “Blanks in list” under SETTINGS it can be determined how many blanks will be shown in

this list:

- Will decrease the number of displayed blanks

by 10.

+ Will increase the number of displayed blanks

by 10.

A maximum number of 90 blanks can be listed.

In general four different possibilities for the determination of the active blank value for the automatic

correction of results are available:

• Blank values can be measured (type: measured).

• Blank values can be entered manually (type: manual).

• Blank values can be calculated as mean value of freely selectable measured blanks (type: mean).

• Blank values can be determined automatically by the system (type: automatic).

The type and the value of the blank currently used for result correction is always displayed in the

results section of the status view:

SHOW STATUS  RESULTS (See section 6.5.1)

Entering Manual blanks

To enter a blank value manually (e.g. for a blank value that has not been determined with the instru-

ment), proceed as follows:

Enter the Blank Correction screen.

Press SETTINGS.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 159 160

Sin comentarios

Buchi KjelSampler K-377 Manual de usuario Pagina 93