Buchi Multivapo P-12 Manual de usuario descargar pdf (Pagina 43)

5 Putting into operation

43 Multivapor™ Operation Manual, Version E

5.5.2 Vacuum tubes

When establishing the vacuum tube (red rubber) connections proceed as follows:

• Use GL-14 tube clips.

• The tubes used must all have the same inner diameter (approximately 5 mm).

• Keep vacuum tubes as short as possible.

• When operating with the Vacuum Controller V-850/V-855 and the Vacuum Pump V-700/V-710

connect a Woulff bottle between the vacuum source and the Multivapor.

• When operating with a pump other than a V-700/V-710, connect a valve unit to the V-850/V-855 to

control the vacuum.

• Tubes do not need to be secured.

• Check the tubes from time to time and replace them if they become brittle.

a Vacuum cover out

b Woulff bottle at Multivapor (optional)

c Condenser vacuum joint

d Woulff bottle at vacuum pump (optional)

e Woulff bottle connection to vacuum pump

f Woulff bottle connection to vacuum controller

Fig. 5.27: Standard vacuum connections with condenser and V-700/V-855 vacuum solution

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 75 76

Sin comentarios

Buchi Multivapo P-12 Manual de usuario Pagina 43