Buchi DuMaster D-480 Manual de usuario descargar pdf (Pagina 291)

Operation Manual D-480 ©BÜCH Labortechnik AG

10 - Menu and dialog descriptions 291

Note

The "Abort analysis" dialog appears.

Observe the notes listed therein. Abort analysis only if either the sample has not been thrown in yet or

has been already completely combusted. In the latter case, make sure that the column does not

retain any element components, i.e. the desorption procedure has been completed. Otherwise, an

abortion leads to system contaminations combined with significant damages.

To abort a running analysis, you have to confirm the note displayed in the dialog first. Only after the

confirmation the Abort analysis button becomes accessible, thus allowing the abortion.

System > Auto zero (Command)

What is the command used for?

This command causes to set the current output values of the dectors to zero. The purpose is to reset

the signals to zero if they have drifted over time.

System > Wake up (Command)

What is the command used for?

This command wakes up the "sleeping" system. The carrier gas is reactivated and the furnaces are

heated back up to their working temperatures. This command is used to manually wake up the

system if you need to start up the system prematurely, i.e. earlier than the chosen wake-up time.

Short cuts

Invocation via the toolbar:

Note

If you have defined a wake-up time that is in the past, you must wake up the sleeping system again

with this command.

Feeding (Dialog)

Function

In this dialog you specify the size of the sample carousel. Make sure that the setting here matches to

the actual size of the sample carousel.

Open

Open the dialog by selecting System > Feeding.

Elements

The following describes the elements of the dialog.

Label

Element type

Meaning

Carousel with {n}

positions

Radiobutton The feeding system is switched to a carousel size of {n}

positions.

Button Saves the setting.

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 355 356

Sin comentarios

Buchi DuMaster D-480 Manual de usuario Pagina 291