Buchi Rotavapo R-220 SE Manual de usuario descargar pdf (Pagina 39)

5 Putting into operation

39 R-220 SE Operation Manual, Version F

Adjustment instructions

• Make sure the foam sensor is installed correctly. Remove the white plastic screw a to get access

to the sensor adjustment screw.

• Allow sufﬁcient foam formation.

• As soon as the foam touches the sensor housing, the LED at the sensor must switch active,

causing the aeration valve to open for an instant. The valve makes a noticable *click* sound!

➥If the sensor does not detect the foam use a small ﬂat head screw driver to adjust the sensitivity

of the sensor.

➡ Check, if the LED switches off as soon as the foam collapses. If not, slightly decrease the

sensitivity and start a new adjustment cycle.

NOTE

The foam sensor can only be used at decending glassware setups!

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 108 109

Sin comentarios

Buchi Rotavapo R-220 SE Manual de usuario Pagina 39